The Sink Base Drip Tray is your first line of defense against under sink cabinet damage from minor leaks. The unique design not only protects the bottom of your cabinet by holding water, the tray actually funnels excessive water to the front of your cabinet and out onto the floor alerting you of the leak. Designed for installation in 30", 36" or 40" sink base cabinet construction, it can be cut down to fit a 27", 33" or 39" cabinet, and the sleek surface makes for easy clean up. NOTE: Recommended for new cabinetry. Product may be difficult to install after sink and counter top are installed.
(W = side to side) (D = front to back) (H = top to bottom)
SBDT-2730: 28-1/2" W x 23-1/4" D x 3/4" H, Minumum Trim: 25-1/2" W x 21-1/2" D SBDT-3336: 34-1/2" W x 23-1/4" D x 3/4" H, Minumum Trim: 31-1/2" W x 21-1/2" D SBDT-3942: 40-1/2" W x 23-1/4" D x 3/4" H, Minumum Trim: 37-1/2" W x 21-1/2" D
Perfect fit by: Lyon H Strong from: Buda, TX on: December 8, 2014
Must be cut to fit. My floor dims. were about 1/4" shorter than the cover dims.
Great protection for sink cabinet by: TL from: San Diego, CA on: May 23, 2012
Easy to customize size. Used Utility
knife and scissors to cut two 2X2
squares on end of front- Fit perfectly
in my 36 kitchen base. Does not get in
the way of doors.
Nice product by: Gail Veitch from: Queenstown, Md on: May 16, 2012
Like product , would have been better if it was a little longer and wider for the fit
Works great! by: Pamela Kennedy from: San Antonio, TX on: April 25, 2012
My contractor had a bit of trouble installing this because the sink and plumbing were already installed and he has "fat fingers" (his words) but it looks great with the silicone caulk and gives the undersink area a very nice look. I like that it will protect my new cabinets in event of a plumbing leak.