The Appliance Lift from Knape & Vogt makes accessing your appliances almost effortless. The appliance lift uses a gas cylinder assist that easily raises and lowers the kitchen appliance. The lift comes with the hardware mechanism, which consists of a left and a right arm. A Maple block in a 13-1/2" or 16-1/2" size is available separately for a pre-made platform option. A wire basket measuring 10" W x 12-1/2" D x 5" H is also available. The appliance lift is covered by a Knape & Vogt Limited Lifetime Warranty.
Width: Platform surface + 2-1/2" W Depth: Maximum of 13" or Platform Depth Height: 23-61/64" H Maple Platform: Minimum Cabinet Space Needed13-1/2" or 16-1/2" W x 18" D x 1-1/2" H Accessory Basket: 9-7/8" W x 12-7/8" D x 4-7/8" H
How much clearance do I need on each side for the brackets. I have a 12 inch wide cabinet opening and the door is half inch into the opening how much space do I need for the bracket to slide out and up so I can figure out how wide the platform could be? Hope that makes sense. - Asked about product KV-HAL-20
This Knape & Vogt Appliance and Kitchen Mixer Lift item is the hardware only. This is for use with your own custom shelf or you can purchase the 13 1/2" or 16 1/2" Shelf. Because you only have 12" of space, you can purchase the 13 1/2" shelf and trim it down to the size you would require.
67% of 3 people found this useful. Was this useful to you? Yes (2) | No (1)
Can your appliance be used while it is on the platform? - Asked about product KV-HAL-20
As long as the maximum weight capacity of 30lbs is not exceeded, appliances can be used while on the lift.
100% of 1 people found this useful. Was this useful to you? Yes (1) | No (0)
Can this product be used in a cabinet under a drawer? - Asked about product KV-HAL-20
No, the appliance lift is for use in a cabinet without a drawer, only.
100% of 4 people found this useful. Was this useful to you? Yes (4) | No (0)