$15.64 - $28.93
No Sales Tax, Except CT
- Arrange cutleries in the kitchen drawer with the cutlery tray
- Four widths available - 11-1/2", 14-1/4", 17-1/2" and 21-7/8"
- All trays are 2-3/8" high
- Rubberized polystyrene to allow easy trimming for a perfect fit in any drawer
- Available in Glossy White, Textured White, Textured Almond and Glossy Metallic Silver finishes
- Ships with clear protective coating that can be peeled off before use
- Limited Lifetime Manufacturers Warranty
The CT/GCT Series Cutlery Trays from Rev-A-Shelf are available in four widths 11-1/2", 14-1/4", 17-1/2" and 21-7/8". The trays are made of rubberized polystyrene to allow easy trimming for a perfect fit in any drawer and are available in Glossy White, Textured White, Textured Almond and Glossy Metallic Silver finishes.
Ships via UPS/FedEx Ground
|Exactly What I Wanted
by: Ian from: Mississauga, ON on: February 22, 2016
| ||Product arrived right on time, well packaged and in perfect shape. The cutlery insert was exactly as advertised and that was great since we needed it to replace our current piece after 15 years. kitchensource.com was the only place we could find it! The customer care people were also very helpful.
|Perfect! I've been looking for this for a while as one was in drawer when we bought house 15 yrs ago. So glad I found a replacement that fits perfectly!
by: Smyers from: Warrior, Al on: November 9, 2015
by: B Green from: -, 38 on: May 12, 2014
by: Edward from: San Antonio, TX on: February 25, 2011
by: anonymous from: -, Tx on: May 20, 2010
| ||Have put these in several homes I have lived in. Trimmable for an exact custom fit to your drawer. Glossy material gives the drawer a nice clean look. Plastic is a little bit brittle so if you are rough on them after 3 years or so once in a while I have cracked one. Easy to replace though.
Nice product. Shipping charge was on the high side.
|Good morning. I have been looking for a cutlery tray for my old Ikea kitchen for years now. The dimensions are 11-1/4" wide by 20" deep. There is one that is close: the GCT/CT2. Is it possible to have it trimmed down just a fraction more, so that it would fit my 11-1/4" x 20" drawer? And if so, what would the cost be for the white one
- Asked about product RV-GCT1S-52
| ||The RV-GCT1W-52 which is 11-1/2 x 21-1/4" D x 2-3/8" H is a trimmable item however it has to be trimmed down on the job site when you receive it. It would require a table saw, hand saw or hack saw to trim the item down to your drawer size.
| ||67% of 3 people found this useful. Was this useful to you? Yes (2) | No (1)|
This item(s) is also sometimes listed under the following manufacturer numbers:
|Rev A Shelf|
CT1A-52, CT1W-52, CT2A-52, GCT2W-52, GCT1W-52, GCT1S-52, GCT2S-52, CT3W-52, GCT3W-52, GCT3S-52, CT4W-52, GCT4W-52, GCT4S-52, CT3A-52, CT4A-52, CT2W-52