 | RV Series
Hampers and Utility Baskets are shipped fully assembled for ease
of installation. First remove the container(s) from the wire
assembly, and place the framework inside your designated space
for installation. In the closed position, insert the front 2
screws (Fig. A), making sure the framework is square with the front of
the cabinet.
If significant clearance is available, proceed to install the
rear 2 screws (Fig. B), and your installation is complete. If clearance
is not available. mark two rear screw locations with a pencil,
pull the framework completely out and on the outside of each
slide, you will find a black trigger (Figure C), which releases
the slides and disassembles the framework from the floor mounted
slides. Remove the framework, line up rear screw locations with
your pencil marks and install the rear screws. Then re-assemble
the framework, and your installation is complete.
Note: If not door mounting, remove black stops on rear of sides.
Note: The HPRV Hamper includes a retaining clip which attaches
to the rear of the hamper (Fig. D.) Simply slide this clip onto
the hamper on the bottom row of holes.
The HURV Utility Basket includes a retaining clip which attaches
to the rear of the basket. (Fig. E.) Simply center this clip
which attaches to the rear of the basket. Simply center this
clip on the third row from the bottom and bend retaining clips
down to keep clip in place.
| | |  | | |  | | |  | | | |    |
