Rev-A-Shelf at Cabinet Accessories Unlimited

E-Z Hider Container Installation Instructions

DIMENSIONS OF UNIT Minimum Dim. of Cabinet Opening
WIDTH...............10-3/4"
HEIGHT..............19-3/8"
DEPTH................18-3/4"		 WIDTH...........................11"
HEIGHT....................19-1/2"
DEPTH...........................22"
Unit Adjusts through spring-action
prongs to cabinets up to 26" deep.
The Installation Instructions and Technical Data for the Rev-A-Shelf®
E-Z Hider are dependent upon the type of cabinets you are installing it in.
 
INSTALLATION FOR FRAMED KITCHEN CABINETS:
FIGURE "A"
  1. PRONG
  2. SPRING
  3. WASHER
  4. RETAINER CLIP
  5. BUSHING
  6. VERTICAL TAB
  7. HOLE FOR SCREW
  1. Assemble prongs by inserting retainer clip into second groove from point. Slip on washer and spring respectively. Insert prongs into bushings (see fig. "A").
  2. Slide whole drawer assembly in horizontal position, using upper rail of cabinet as a guide, until prongs meet back of cabinet or wall.
  3. Apply pressure & lift front of unit slightly so that vertical tabs come to rest flush against inside of rail. (If there is too much or too little tension, adjust by moving retainer clip accordingly).
  4. Fasten unit to oak rail with 2 screws. For easier fastening of all screws, drill or piece starter holes.
  5. Slide out drawer & fit plastic container in place. Drop in large shopping bag or any other suitable liner.

    The E-Z Hider is furnished with a solid deodorizer. Peel wrapping to activate.
INSTALLATION FOR FRAMELESS KITCHEN CABINETS:
FIGURE "A"
  1. PRONG
  2. SPRING
  3. WASHER
  4. RETAINER CLIP
  5. BUSHING
  6. VERTICAL TAB
  7. HOLE FOR SCREW
  8. BRACKETS
  9. HOLES FOR MOUNTING
  10. OAK RAIL - not supplied
  11. HOLES FOR SECURING OAK RAIL
  1. To fasten oak rail you must have a minimum of 19-1/2" from bottom of cabinet to bottom of bracket (See fig. B). Fasten brackets (#8 L-R) to sides of cabinet (9). Fit and mount oak (#10) into brackets, secure rail to brackets (11).
  2. Assemble springs by inserting retainer clip into second groove from point. Slip on washer and spring respectively. Insert prongs into bushings (see fig. "A").
  3. Slide whole drawer assembly in horizontal position, using oak rail as a guide, until prongs meet back of cabinet or wall.
  4. Apply pressure & lift front of unit slightly so that vertical tabs come to rest flush against inside of rail. (If there is too much or too little tension, adjust by moving retainer clip accordingly).
  5. Fasten unit to oak rail with 2 screws. For easier fastening of all screws drill or pierce starter holes.
  6. Slide out drawer & fit plastic container in place. Drop in large shopping bag or any other suitable liner.

    The E-Z Hider is furnished with a solid deodorizer. Peel wrapping to activate.